I just finished up a playfield transfer. Working great. I did a rookie mistake:First check that you didn't either bend or break off one or two pins of
I pulled off the smaller ribbon cable that goes from CPU board to the '8-driver PCB Assembly'. When I put it back on, I missed it by a > column. I corrected that and now the Idol and Upper Playfield do not work.
I figure I fried something on that board.
Can anyone save me a little time and tell me what I need to replace?
Thanks.
I hate ribbon cables.......
On 2021/04/06 2:35 p.m., LexingtonVAPin wrote:
I just finished up a playfield transfer. Working great. I did a
rookie mistake:
I pulled off the smaller ribbon cable that goes from CPU board to the
'8-driver PCB Assembly'. When I put it back on, I missed it by a
column. I corrected that and now the Idol and Upper Playfield do not
work.
I figure I fried something on that board.
Can anyone save me a little time and tell me what I need to replace?
Thanks.
I hate ribbon cables.......
First check that you didn't either bend or break off one or two pins of
the pin header connector...
John :-#)#
On 4/6/21 5:53 PM, John Robertson wrote:
On 2021/04/06 2:35 p.m., LexingtonVAPin wrote:
I just finished up a playfield transfer. Working great. I did a
rookie mistake:
I pulled off the smaller ribbon cable that goes from CPU board to the
'8-driver PCB Assembly'. When I put it back on, I missed it by a
column. I corrected that and now the Idol and Upper Playfield do not
work.
I figure I fried something on that board.
Can anyone save me a little time and tell me what I need to replace?
Thanks.
I hate ribbon cables.......
First check that you didn't either bend or break off one or two pins
of the pin header connector...
John :-#)#
Thanks John. The pins are fine.
I have not done the research to find out how the '8 driver PCB Assembly' works or integrates into the pin.
When I go into the test of the upper playfield and the Idol, I get an
error message. Not sure what roll this ribbon cable and the '8
driver-' has to do in the game. I need to do more research. It looks like it controls the motors and that might not be where the error is?
If you have any experience or insight into how this works, please let me know.
Sysop: | Gary Ailes |
---|---|
Location: | Pittsburgh, PA |
Users: | 106 |
Nodes: | 5 (0 / 5) |
Uptime: | 118:22:35 |
Calls: | 588 |
Files: | 2,171 |
Messages: | 65,033 |